mine is still misbehaving, clear codes and 5 miles later i get eml and limp again. cycle the ignition and get power for about half a mile before limp hits again.
read it with launch today and got
6 codes.
1. dust filter(fap) maximum number of regens reached. 2. pre post heating relay
circuit relay controlled and spark plugs not supplied. 3. EGR circuit air flow measured higher than the reference value. 4.EGR valve circuit too much egr, egr valve too open in relation too the reference value. 5. EGR solonoid valve sticking of the valve while driving. 6. EGR solonoid valve sticking of the valve on programming its values.
Not sure if all this refers to egr tho now i look at it? Havnt had the launch long and just noticed it has no code numbers on the printout?