Dave Hill
""Scope the cam and crank signals together, then you can compare and see if they corralate.""
Is there a way of confirming the correlation without some prior research or other data?
Hi Liam
If you unplug the crank sensor it will most likely start up after several seconds. It is likely that you do have a correlation issue & the system will not authorise a start condition.
without a crank signal the system can calculate the correct phase & will run, albeit in limp home mode.
Of course this is skirting around the issue. Your timing is incorrect & needs addressing.
HTH
Dave
Message Thread | This response ↓ 
VW Passat 2.0 BKP 2006 - Non start after timing belt replacement - Fixed # - Liam Hourihan October 17, 2010, 9:21 am
« Back to index | View thread »
on October 18, 2010, 7:59 pm, in reply to "