Re: Peugeot 406 HDi, W plate, non-starter Archived Message
Posted by Bryan Smith on October 18, 2008, 3:43 pm, in reply to "Re: Peugeot 406 HDi, W plate, non-starter"
The readings do seem lower than Mark Carter has suggested so perhaps it is a fuel pressure problem (although 300A on the starter does seem high). I have very little experience of these CR high pressure pumps so can't comment on your test results. Mark, is the test with the DRV disconnected supposed to diagnose as to whether it's the DRV or the pump that is at fault (assuming the test figures are too low). If not, is that test possible with normal workshop equipment? regards to all, Bryan.
|
Message Thread:
- Peugeot 406 HDi, W plate, non-starter - Peter Rainsley October 15, 2008, 8:30 am
- Re: Peugeot 406 HDi, W plate, non-starter - simon dean October 15, 2008, 6:17 pm
- Re: Peugeot 406 HDi, W plate, non-starter - Peter Rainsley October 15, 2008, 7:53 pm
- Re: Peugeot 406 HDi, W plate, non-starter - george rayner October 15, 2008, 9:12 pm
- Re: Peugeot 406 HDi, W plate, non-starter - Tony Sefton October 15, 2008, 10:30 pm
- Re: Peugeot 406 HDi, W plate, non-starter - Steve Shaw October 15, 2008, 10:47 pm
- Re: Peugeot 406 HDi, W plate, non-starter - Mark Carter October 15, 2008, 11:30 pm
- Re: Peugeot 406 HDi, W plate, non-starter - TONY VAMPLEW October 15, 2008, 11:53 pm
- Re: Peugeot 406 HDi, W plate, non-starter - Peter Rainsley October 16, 2008, 8:37 am
- Re: Peugeot 406 HDi, W plate, non-starter - Bryan Smith October 16, 2008, 9:03 am
- Re: Peugeot 406 HDi, W plate, non-starter - Mark Carter October 16, 2008, 7:07 pm
- Re: Peugeot 406 HDi, W plate, non-starter - martin young October 16, 2008, 8:09 pm
- Re: Peugeot 406 HDi, W plate, non-starter - lee mackintosh October 16, 2008, 10:15 pm
- Re: Peugeot 406 HDi, W plate, non-starter - Peter Rainsley October 16, 2008, 10:33 pm
- Re: Peugeot 406 HDi, W plate, non-starter - Peter Rainsley October 18, 2008, 9:57 am
- Re: Peugeot 406 HDi, W plate, non-starter - kevin adam October 16, 2008, 10:48 pm
|
|