Re: Peugeot 406 2.0 HDI 110 RHZ Bosch EDC 15C2 Archived Message
Posted by Colin Hedger on September 27, 2008, 6:08 pm, in reply to "Re: Peugeot 406 2.0 HDI 110 RHZ Bosch EDC 15C2"
Dave, At home now, but sensor was underneath fuel rail,towards the end on the right (gearbox end).Cant remember how many wires it had. Only other elec connection on rail was fuel temp which i disconnected as well .I even tried disconnecting both of these,plus all elec connections at hp pump.Launch still showed 0 bar ign on, 392bar cranking. Could these be some sort of default values it shows if there is a problem,and not real values at all? Need to check the voltage at sensor as you suggest on Mon. Do you think the Launch code means pressure signal from the sensor or to the regulator? Thanks for your help so far Dave, Colin.
|
|