Re: Difficult opening after firing Archived Message Posted by Bill Graham on March 17, 2017, 12:56 pm, in reply to "Re: Difficult opening after firing" The firing pin is hitting so hard, or going so deep, that the primer is being pressed into the slots in the bushings. The marks at 2 and 8 are not drag marks but are raised sections of primer case. Message Thread: Difficult opening after firing - Bill Graham March 15, 2017, 9:44 am Re: Difficult opening after firing - David Williamson March 15, 2017, 10:32 am Re: Difficult opening after firing - Randy Roberts March 15, 2017, 3:13 pm Re: Difficult opening after firing - Bill Graham March 15, 2017, 4:32 pm Re: Difficult opening after firing - David Williamson March 15, 2017, 5:58 pm Re: Difficult opening after firing - Bill Graham March 15, 2017, 10:06 pm Re: Difficult opening after firing - Bill Graham March 16, 2017, 4:20 pm Re: Difficult opening after firing - David Williamson March 16, 2017, 6:04 pm Re: Difficult opening after firing - Bill Graham March 16, 2017, 7:46 pm Re: Difficult opening after firing - David Williamson March 16, 2017, 8:57 pm Re: Difficult opening after firing - Bill Graham March 17, 2017, 12:56 pm Re: Difficult opening after firing - David Williamson March 17, 2017, 2:10 pm Re: Difficult opening after firing - Bill Graham March 17, 2017, 2:35 pm Re: Difficult opening after firing - Bill Graham March 17, 2017, 6:57 pm Re: Difficult opening after firing - David Williamson March 17, 2017, 8:25 pm Re: Difficult opening after firing - Bill Graham March 18, 2017, 11:44 am Re: Difficult opening after firing - Robert Rambler April 2, 2017, 8:52 am All about the primers - Bill Graham March 20, 2017, 9:44 am Re: All about the primers - David Williamson March 20, 2017, 4:15 pm Re: All about the primers - Jamie April 1, 2017, 6:23 pm Re: All about the primers - Bill Graham April 1, 2017, 6:31 pm Re: Winchester Low Recoil Specs - Bill Graham April 3, 2017, 4:00 pm Re: Winchester Low Recoil Specs - David Williamson April 3, 2017, 6:14 pm Re: Winchester Low Recoil Specs - Bill Graham April 3, 2017, 7:46 pm Closing this thread - Jim Stubbendieck April 4, 2017, 7:33 am   Searching