--Previous Message--
: Thanks Scott. Your description of the
: spreader is good enough that I don't
: think I need a picture. It certainly
: sounds easy enough to make. My only
: question is how thick was the angle you
: used for the spreader
: (2"x2"x?") ?
:
: As mentioned earlier, I won't know
: until I carefully examine the gear
: teeth if my spare diff will be worth
: rebuilding.
:
: Doug L.
:
:
: --Previous Message--
: I would offer that a diff case spreader
: is very easy to make, and if you really
: have to go through the adjustment
: process a few times, it's worth it. I
: made one with two pieces of 2"
: angle iron and two allthread rods.
: Bolt the angle iron to the diff on the
: left and right, holes in the
: "vertical" of the angle for
: the all-thread, a couple of nuts and
: you're there. Having recently rebuilt
: two GT6 diffs, one in the car and one
: spare (race car, always need spares), I
: found the instructions in the manual
: initially intimidating, but once you
: get into it things make sense.
: I can send a photo of my homemade
: spreader if you wish.
:
:
Responses