Re: Need advice, considering new Boyd's stock Archived Message
Posted by Chuck Weigle on November 4, 2012, 5:45 pm, in reply to "Re: Need advice, considering new Boyd's stock"
Hi david, many thanks for the helpful info. Yes, the finger ends are slanted/cut at an angle sits not the flat one. Yes on the single scew as well holding the lock plates on.... I figured I'd have to do some sanding to get the Boyd's to fit just right, hopes can get that right. I'm planning on ordering it with the checkering... What's interesting too about this disassembly is that when pulled the old stock off, the little small safety lever fell out on the table...l was trying to be careful, hope I can figure out how it (the safety lever) goes back together! Thanks, chuck
|
|