Re: SPRINTER 311 CDI 51 PLATE/POOR START/MISFIRE Archived Message
Posted by simon dean on October 27, 2009, 7:36 pm, in reply to "Re: SPRINTER 311 CDI 51 PLATE/POOR START/MISFIRE"
Hi Darren. Thanks for that i think i have a wiring fault as you say. I did a leak off test cranking and thought it was a little high on 3 injectors so sent them for test. Bosch agent tested the injectors so i am happy with their diagnosis that all is well. Will have a look at the loom tommorow,i do have open circuit faults and low/no volts faults for injectors so sure i may find damaged wiring.Also glow plugs all cylinders. I dont have the p code so will look at this if needed,this seal is behind the rail pressure sensor then-the one that screws into the rail osf as you look at it? Post what i find tomoz Thanks Simon
|
|