replies Archived Message
Posted by Andy Gladish on February 28, 2007, 11:12 pm, in reply to "Re: peugeot expert 2.0 hdi 2000 RHX bosch EDC15C2"
Hi Martin
I did (try) scope the rpm sensor on wire side of ecu on cranking,to be honest i did get a trace but it was a bit fiddley trying to hold probe/plug/ecu/wires/scope/,it was a half hearted attempt as i assumed it would require rpm to run?
And as a said it starts fine with a short tow.
Thanks for looking
Andy.
|
| Message Thread:
- Peugeot Expert 2.0 HDi 2000 RHX Bosch EDC15C2 - replaced clutch , now will not start, tow start # - Andy Gladish February 28, 2007, 9:49 pm
- replies - martin young February 28, 2007, 10:53 pm
- replies - Andy Gladish February 28, 2007, 11:12 pm
- replies - Phil Dunmore March 1, 2007, 8:15 pm
- replies - Andy Gladish March 1, 2007, 8:38 pm
- replies - andy gladish March 2, 2007, 5:31 pm
- replies - martinyoung March 2, 2007, 6:44 pm
- replies - Andy Gladish March 2, 2007, 7:45 pm
- replies - Darren Jones March 2, 2007, 8:09 pm
- replies - Andy Gladish March 2, 2007, 9:48 pm
- replies - paul m marshall March 2, 2007, 10:34 pm
- replies - martin young March 2, 2007, 11:23 pm
- replies - aidan birley March 3, 2007, 8:48 pm
- replies - Andy Gladish March 3, 2007, 10:12 pm
- replies - Andy Gladish March 20, 2007, 9:43 pm
- replies - martin young March 21, 2007, 8:01 am
|
|