Year of Manufacture *: 2008 (58)
Engine Size and Code *: 1600 HDI 9HZ
( Optional ) ECU Type: Bosch EDC16C3
( Optional ) Scanner Used: Peugeot Planet, DEC, LAUNCH. BRAINBEE.
( Optional) Fault Codes: P0181 P0048 P0034 P0047 P0195 P0196 P0162
ABS ok I have configured to car tyre size engine etc and that has coms however engine does not appear to be talking to BSI or each other. I have coms I have coded keys and Peugeot Planet reports back that code in BSI and ECM is the same but no crank. Have checked starter all ok (direct power and turns engine).
The ECM has loads of faults P0181 fuel temp sensor P0048turbo pressure P0034 turbo by pass sol P0047 turbo press P0195 engine oil temp P0196 oil temp & P0162 O2 sensor. They are mainly open circuit to temp sensor fuel temp sensor and turbo by pass I think the fault codes may be to do with software it was reported to drive in to garage ok. I think I need to concentrate on coms/programing first. I have the old ECM that has been returned by ECU testing as not repairable and there is no coms with that. The ECM was purchased by garage from Torqu Tronics in Ireland. They say they partly clear the ECM. Earth leads all checked. Any help with matching the secondhand units is this possible to do ? Has anyone experience of purchasing access to Peugeot site on hourly basis regards Dave
Message Thread
« Back to index | View thread »