Peugeot 307 1.4 HDi 8HZ 2002 - Non start after oil pump replacement, code P0338 - Fixed #
Posted by Mark Robins on May 6, 2011, 1:07 pm
Message modified by board administrator May 16, 2011, 2:35 pm
Year of Manufacture *: 2002
Engine Size and Code *: 1.4 HDI 8HZ
( Optional ) ECU Type: Bosch EDC16C3
( Optional ) Scanner Used: Autocom
( Optional) Fault Codes: P0338 Crankshaft Position Sensor A Circuit High in
Vehicle is a non-starter after oil pump replacement, Scoped both the Cam and crank sensors (hall type square wave) Amplitude of cam sensor signal is 11.5v, amplitude of crank sensor is 7.5v. As both sensors are identical in function; and voltage applied to sensors is 5v I'm thinking ECU problem. Ive checked ground on senors and ECU both OK, Data says amplitude and voltage to sensors should be 5V approx. Also checked continuity between ECU and sensors, also ECU grounds are OK.
Any insight greatly appreciated.
Mark
|
