Re: Interesting Archived Message Posted by David Williamson on July 12, 2015, 10:03 am, in reply to "Re: Interesting " Bill, some of the earlier cocking tools did not have the hole in the one end and were used on the locks to cock the hammer/s or remove the mainspring. I believe Phil Carr put one on the site a while back that had no hole and if the same one was used by one of the workers at Hunter Arms Co. The ones made today are exact reproductions of the one seen in Brophy's book. Neat tool to have but I find a 4" adjustable wrench easier to use in cocking the cranks. Message Thread: Interesting - David Williamson July 8, 2015, 4:09 pm On the other hand :) - Drew Hause July 8, 2015, 4:53 pm Re: Interesting - John Liles July 8, 2015, 5:12 pm Re: Interesting - David Williamson July 8, 2015, 5:39 pm Re: Interesting - Steve Arnett July 8, 2015, 8:28 pm Re: Interesting - Tom Martin July 9, 2015, 7:19 am Re: Interesting - Steve Arnett July 10, 2015, 7:53 am Re: Interesting - Bill Murphy July 10, 2015, 2:29 pm Re: Interesting - David Williamson July 12, 2015, 10:03 am Re: Interesting - mark July 27, 2015, 12:36 pm   Searching