The SteelNavy.Com Message Board: Re: SS Model 3D printed USS Baltimore

[ Post a Response | The SteelNavy.Com Message Board ]

Re: SS Model 3D printed USS Baltimore - anyone seen this model...

Posted by David Sandifer on December 25, 2025, 17:51:08, in reply to "SS Model 3D printed USS Baltimore - anyone seen this model..."

Yes, Simon, I purchased the full hull version a month ago. The 3D parts are beautifully done, BUT the hollow four-part segmented hull is a real headache. Please share your progress with me: dsand47702@aol.com

Responses

Have not bought it yet. So the hull is two part above and two part below? - Simon Scheuer December 25, 2025, 18:48:32
- Re: Have not bought it yet. So the hull is two part above and two part below? - David Sandifer December 25, 2025, 20:41:01
  - Re: Have not bought it yet. So the hull is two part above and two part below? - Robert Apfelzweig December 26, 2025, 11:23:43
  - Glue a modest, rectangular, piece of resin to the inside of a section. Let it protrude so it goes.. - Simon Scheuer December 26, 2025, 10:21:27

« Back to index

Post a Response

SteelNavy.Com Home Page