Ford Transit 2.0 TDCi FIFA 2004 - No comms with scanner - Fixed #
Posted by Shane Gray on August 8, 2013, 9:30 pm
Year of Manufacture *: 2004 Engine Size and Code *: 2.0 tdci FIFA ( Optional ) Scanner Used: Mac tools
Hi all, Got this transit in because it cuts out when warm and can take a while to restart. I plug the scanner in and it would not communicate, I checked live and earth at dlc and there fine,, checked for voltage on can lines and I get 4.6 volts on can high but no voltage on low. Checked resistance and there is non. Should be 60 ohms I think ? Looking at wiring diagram can lines go straight to ecu and parallel to cluster . Do you think this is just a simple case of broken wire or fault with module? Haven't checked anything else yet as very busy today on other vehicles. Not much experience with can, so any help will be appreciated . Thanks in advance Shane
Fixed #
Posted by Shane Gray on August 9, 2013, 4:47 pm, in reply to "Ford / transit no comms with tester" Edited by board administrator August 12, 2013, 1:36 pm
Hi again, Took connector off cluster cleaned and refitted now I have comms. Just like magic Shane