Hi all,
Got this transit in because it cuts out when warm and can take a while to restart.
I plug the scanner in and it would not communicate, I checked live and earth at dlc and there fine,, checked for voltage on can lines and I get 4.6 volts on can high but no voltage on low. Checked resistance and there is non. Should be 60 ohms I think ?
Looking at wiring diagram can lines go straight to ecu and parallel to cluster . Do you think this is just a simple case of broken wire or fault with module?
Haven't checked anything else yet as very busy today on other vehicles.
Not much experience with can, so any help will be appreciated .
Thanks in advance
Shane