Back to Forum
Post a Response
    Re: Removing CR Injectors Job done!! Archived Message

    Posted by Philip Cockburn on September 10, 2008, 10:09 pm, in reply to "Removing CR Injectors"

    Hi Chaps
    Thank you all for your thoughts & advice here.
    After a good old think over some fermented barley, we decided to buy Darwen Diesels kit & wire in, I can say that it took a lot longer to gain enough access on this engine than we appreciated & although we still did not manage to lower the engine enough to use the hyd part of the kit, we used the manual part & slowly screwed the injector out (cracking & banging as it went).
    Our thought on buying the kit are to offer this to other garages as an alternative to removing heads, which means you dont have to replace all four at the same time & fit new belt kit, waterpump etc, we did also explain this to the woefull owner, who I think did understand this, although it did not stop his hand from shaking as he squeezed his Visa card into the machine, or making his eyes/face look rather like he had just been done up the back by Lindford Christie!.
    Thank you all again, Philip Cockburn

    Message Thread:


Copyright © uk autotalk