Hi All

Need a little help. Been a few places and has an in tank fuel pump and ecu been checked. Also had a crank sensor fitted at the dealers, but old one put back on. Will start and cuts out as soon as revs reach 1200. like someone switching off. Code P1E25 comes back.Not scoped cam sensor yet but feel if it starts should keep going even if cam faulty.The under bonnet fuel pump is noisy. getting 2.5bar when tested. Could this be from new in tank pump. As there are two low pressure pumps, why do you need two? Disconnected the fuel pressure sensor to check for corrosion. OK. Getting an earth and 5 volts. With Solus I am getting 3.46bar delivered pressure. Connect sensor back and now no start and code P1260. At tick over Map+980. acc pedal pos 1 at tick over =7.9% with acc pedal pos 2= 0%. Both at 100% at WOT. Hope all the above makes sense.

Best regards

Les