Hi all
Had the above vehicle in yesterday with the message particulate filter regeneration cyle urgent coming up on the centre console and a picture of a particulate filter on the dash. Fault coded the engine and the additive ecu's and no fault codes present. Checked in live data in the engine ecu the particulate filter load was 18% and the pressure sensor difference with the KOEO was 0 millibar KOER was 0 millibar a good hard rev and it went up to about 20 millibar. KOEO with a mityvac gauge on the rear pipe of the pressure sensor at 5 in hg the reading in live data was 117 millibar and it should been about 160 millibar i think, so i decided to replace the sensor but still no good the message kept coming up on start up. Took the vehicle for a long run but still no good, i then decided to reset the filter replacement and the light doesnt come on any more. What i was wanting is a bit of advice regarding the filter should i change or leave it? The vehicle has done 66,000 miles, sorry for the long post any advice would be most appreicated.

Regards Jamie