Re: First Type Barrel Check Archived Message Posted by David Williamson on September 22, 2018, 6:27 am, in reply to "Re: First Type Barrel Check" Marcus, best to take firing pins out and clean housing with a Q-tip with Hoppe's or what ever bore cleaner you use. You might be surprised how much crud is in there causing the firing pins not to go back easily. Message Thread: Opening & closing - Steve Gilbert September 11, 2018, 9:50 pm To Hard To Open & Close The Barrels - Jent P Mitchell III September 11, 2018, 11:40 pm Re: To Hard To Open & Close The Barrels - Steve Gilbert September 12, 2018, 9:12 pm Re: To Hard To Open & Close The Barrels - David Williamson September 13, 2018, 7:26 am Re: To Hard To Open & Close The Barrels - Steve Gilbert September 13, 2018, 7:37 am First Type Barrel Check - Drew Hause September 13, 2018, 8:12 am Re: First Type Barrel Check - Stan Hillis September 17, 2018, 8:28 pm Re: First Type Barrel Check - Marcus Merritt September 21, 2018, 9:23 pm Re: First Type Barrel Check - David Williamson September 22, 2018, 6:27 am Re: First Type Barrel Check - Marcus Merritt September 28, 2018, 5:09 pm Re: First Type Barrel Check - Steve Gilbert October 30, 2018, 1:13 pm Buck Hamlin contact - Drew Hause October 30, 2018, 1:33 pm Re: Buck Hamlin contact - Steve Gilbert October 30, 2018, 2:15 pm Re: To Hard To Open & Close The Barrels - Steve Gilbertj September 13, 2018, 7:40 am Re: Opening & closing - Mark Skipper September 13, 2018, 9:29 pm Re: Opening & closing - David Williamson September 14, 2018, 6:58 am   Searching