Re: Where were my barrel tubes made? Archived Message
Posted by Michael Harris on September 8, 2017, 9:51 am, in reply to "Re: Where were my barrel tubes made?" |
Roger, I'm thinking that you should write an article on this! My opinion is that all Damascus barrels were made in Belgium and Hunter sourced all of their barrels from overseas. I know the connection with the steel factories here in the U.S. but remember that there was steel used in the frames and parts that went into the manufacturing of the guns. From what I have read, getting barrels from Europe was the most economical thing to do since wages over there were a lot less than they were over here so it only makes sense to me that they were sourced there. It has been in writing in quite a few papers and articles. Just my thoughts. Mike
|
Message Thread:
- Where were my barrel tubes made? - Drew Hause September 2, 2017, 10:31 am
- Re: Where were my barrel tubes made? - Tom Breeden September 2, 2017, 3:08 pm
- Re: Where were my barrel tubes made? - Doug September 2, 2017, 6:38 pm
- What about Decarbonized barrels? - Drew Hause September 3, 2017, 10:22 am
- What about these makers? - Drew Hause September 3, 2017, 10:27 am
- Re: Where were my barrel tubes made? - C Helms September 5, 2017, 3:23 pm
- Well done Bro. Roger! - Drew Hause September 18, 2017, 4:46 pm
- Re: Where were my barrel tubes made? - David Williamson September 18, 2017, 8:43 pm
|
|