The SteelNavy.Com Message Board: .24" or 6.096mm. did that on a 1/350 Gearing

[ Post a Response | The SteelNavy.Com Message Board ]

.24" or 6.096mm. did that on a 1/350 Gearing

Posted by David on March 31, 2026, 7:16:10, in reply to "Converting a 1/700 Gearing class to a Sumner class"

for a member on another site.

Previous Message

I know that the Sumner class was 14ft shorter than the Gearing class. How much to I need to cut between the funnels?

Bob

Re: .24" or 6.096mm. did that on a 1/350 Gearing - Bob Pienkos March 31, 2026, 14:45:32
- you are welcome. nt - David March 31, 2026, 16:56:24
Should be the area right under the practice reloader... N/T - Mike E. March 31, 2026, 11:09:55
- Re: Should be the area right under the practice reloader... N/T - Bob Pienkos April 1, 2026, 6:21:36

« Back to index

Post a Response

SteelNavy.Com Home Page