The SteelNavy.Com Message Board: Converting a 1/700 Gearing class to a Sumner class

[ Post a Response | The SteelNavy.Com Message Board ]

Converting a 1/700 Gearing class to a Sumner class

Posted by Bob Pienkos on March 31, 2026, 5:39:42

I know that the Sumner class was 14ft shorter than the Gearing class. How much to I need to cut between the funnels?

Bob

.24" or 6.096mm. did that on a 1/350 Gearing - David March 31, 2026, 7:16:10
- Re: .24" or 6.096mm. did that on a 1/350 Gearing - Bob Pienkos March 31, 2026, 14:45:32
  - you are welcome. nt - David March 31, 2026, 16:56:24
- Should be the area right under the practice reloader... N/T - Mike E. March 31, 2026, 11:09:55
  - Re: Should be the area right under the practice reloader... N/T - Bob Pienkos April 1, 2026, 6:21:36

« Back to index

Post a Response

SteelNavy.Com Home Page