The SteelNavy.Com Message Board: Re. Sectioned hull 3d printed 1/700 kit

[ Post a Response | The SteelNavy.Com Message Board ]

Re. Sectioned hull 3d printed 1/700 kit

Posted by Mark Rowlands on February 18, 2026, 1:35:03

Hello,
No doubt this has been discussed before, but is there any advice on how best to deal with a 3d printed kit in which the hull (waterline) is in two separate fire and aft sections?
Many thanks.

Responses

Re: Re. Sectioned hull 3d printed 1/700 kit - SteveO February 18, 2026, 5:31:07
- Re: Re. Sectioned hull 3d printed 1/700 kit - Mark Rowlands February 18, 2026, 7:37:56
Re: Re. Sectioned hull 3d printed 1/700 kit - Mark Rowlands February 18, 2026, 3:56:28
- Re: Re. Sectioned hull 3d printed 1/700 kit - Alan February 18, 2026, 9:41:25
  - Re: Re. Sectioned hull 3d printed 1/700 kit - Mark Rowlands February 18, 2026, 10:01:22

« Back to index

Post a Response

SteelNavy.Com Home Page