[ Post a Response | The SteelNavy.Com Message Board ]
Posted by Alan on February 18, 2026, 9:41:25, in reply to "Re: Re. Sectioned hull 3d printed 1/700 kit"
I have that kit so I hope you post how it goes together as I have not yet started on it.
Previous Message
I should add that the kit is the MRY-SFW SSC700609-A HMS Indomitable aircraft carrier. There appears to be a flange at the end of each section. To what extent does that need to be filed off? Previous Message
Hello,
No doubt this has been discussed before, but is there any advice on how best to deal with a 3d printed kit in which the hull (waterline) is in two separate fire and aft sections?
Many thanks.
Responses