Yes the housing bore spec for the early bearings is 1.9695 (high end), the bearings fit right in if the bore isn't out of spec, and use the small journal bumpstick.
Glen
--Previous Message--
: Good point.
:
: Is there a known-good running
: clearances for cam journals? If the
: clearance is too large (based on the
: wear in the block bores) can the block
: be bored for cam bearings?
:
: Doug L.
:
: --Previous Message--
: Sounds like you are in pretty good
: shape.
: Don't forget to mic the cam journals
: & housing bores, excessive wear
: here isn't always apparent to the old
: eyeball, and excessive clearance will
: kill low speed oil pressure.
: Glen
:
:
Responses