Re: firing pin bushing repairs by Mark B. of MBAB LLC Archived Message
Posted by mark on September 2, 2015, 2:47 pm, in reply to "firing pin bushing repairs by Mark B. of MBAB LLC"
Nice Jent. New bushings and pins too? Was that problem caused by a pierced primer or from trying to remove a stuck bushing? Mine is not broken yet, just stuck, so far. I'm giving it a rest right now. I'm going to soak it some more as Dave suggested and I may try the cold method after that before I torque it again, maybe an impact screw gun too. I didn't really heat it much because of the proximity to wood and I'm using hollow ground screw driver bits, though I am running out of the proper size. I'll get it, I'm just looking for helpful hints.
|
|