Re: forend wood Archived Message Posted by Steve on April 26, 2008, 10:17 am, in reply to "forend wood" ok - got the forend stripped (it was covered with chipped and cracked varnish - when my wife saw it, her comment was, "you paid $35 for a piece of plastic?!) - and this time I didn't use sandpaper After staining, and treatment with tru-oil, stock sheen & conditioner and gun stock wax, it matches the stock very well. I Ordered the metal parts that numrich has on it's site. The only parts they didn't have in stock were the forend spring pin, forend retracting spring, rear forend screws, and cocking plate screw. Guess I'll try to be patient and check frequently to see if they happen to get them in, and when I run out of patience take it to a local gun guy to have him manufacture some parts... Making progress! Steve Message Thread: Personal renovation project - SteveJ February 17, 2008, 11:56 pm Re: Personal renovation project - David W February 18, 2008, 9:04 pm Re: Personal renovation project - Steve February 19, 2008, 8:00 pm forend wood - Steve April 25, 2008, 6:08 pm Re: forend wood - Steve April 26, 2008, 10:17 am Re: forend wood - bobby April 25, 2008, 9:15 pm Re: forend wood - Steve April 25, 2008, 9:24 pm Re: forend wood - bobby April 26, 2008, 9:06 pm Re: forend wood - Steve April 27, 2008, 6:04 am   Searching