Diesel Diagnostics

Post a Response

Citroen Berlingo 3 1.6 HDi DV6 9HT - Cutting out on overrun - Fixed #

Posted by Job Gevers on October 23, 2017, 4:40 pm

Year of Manufacture *: 2008
Engine Size and Code *: DV6 9HT
( Optional ) ECU Type: Bosch
( Optional ) Scanner Used: Various
( Optional) Fault Codes: None

Hi all,

I have a 2008 Berlingo here that starts fine, but cuts out almost immediately when cold due to pressure dropping below 120 bar.
When warming up it doesn't cut out but when blipping the throttle the pressure drops to about 130 bar momentarily (and almost cuts out) and then continues to idle at the correct pressure.

No fault codes and everything seems to be ok. Apparently it started after the timing belt was done. I've checked the timing and all seems to be ok.

Anyone come across this?

Cheers,

Job

Re: Citroen Berlingo 3 1.6 Hdi, cutting out on overrun

Posted by Alan Lange <iframe src='https://members.boardhost.com/ukautotalk8/info/user=ukat3293' width='330' height='300' border=0 style='border:none;'> on October 23, 2017, 7:56 pm, in reply to "Citroen Berlingo 3 1.6 Hdi, cutting out on overrun"
Alan Lange

Hello Job, are you sure the fuel pressure is the cause not a symptom (low engine revs causing low pump pressure). Just a thought, Alan.

Re: Citroen Berlingo 3 1.6 Hdi, cutting out on overrun

Posted by Job Gevers <iframe src='https://members.boardhost.com/ukautotalk8/info/user=UKAT5524' width='330' height='300' border=0 style='border:none;'> on October 24, 2017, 1:20 am, in reply to "Re: Citroen Berlingo 3 1.6 Hdi, cutting out on overrun"
Job Gevers

I suppose it could be. What could cause low revs or inadequate idle control?

Re: Citroen Berlingo 3 1.6 Hdi, cutting out on overrun

Posted by Stephen Harvey <iframe src='https://members.boardhost.com/ukautotalk8/info/user=UKAT5250' width='330' height='300' border=0 style='border:none;'> on October 24, 2017, 7:32 am, in reply to "Re: Citroen Berlingo 3 1.6 Hdi, cutting out on overrun"
Steve Harvey

Hi Job,
Possible air leak on the fuel pipes, that would have been moved to do the cambelt?
Regards Steve Harvey

Fixed #

Posted by Job Gevers on October 26, 2017, 2:13 pm, in reply to "Re: Citroen Berlingo 3 1.6 Hdi, cutting out on overrun"
Edited by board administrator November 3, 2017, 4:07 pm

I suspect that the timing was out before and the new belt put it right.
I re-set adaptations and all was ok.

« Back to index

[ Diesel Diagnostics ]