Peugeot Bipper 1.4 HDi 2010 - Slowley lost power and stopped #
Posted by Steve Sneap on November 15, 2013, 8:51 am
Year of Manufacture *: 2010 84.000 miles Engine Size and Code *: 1.4 hdi ( Optional ) Scanner Used: Solus pro ( Optional) Fault Codes: non
Morning All
this van slowly lost power and stopped, recovered, checked fault codes no dtc s, changed fuel and air filter and it started ok. Customer took it away next day after about 20 miles same thing. No fault codes but this time checked data and surprised to see ECT -40 new sensor fitted snd its the same. However if I go in through EOBD the ECT is correct. I now suspect the ecu...any thoughts?
Steve Sneap.
Re: Peugeot Bipper
Posted by Kevin Apps on November 15, 2013, 9:47 am, in reply to "Peugeot Bipper"
Steve
Get it on another code reader. Also check the forum for similar problem,s with the CTS.
Kev.
Re: Peugeot Bipper
Posted by Ian Slattery on November 16, 2013, 5:49 pm, in reply to "Re: Peugeot Bipper" Ian Slattery
Hi Steve
On these bippers the first place to look is on the harness at the back of the engine[ near the bulkhead on the cam belt side].
If you take the cover of and pull on them as it goes down from the cam cover [where it is easy to get to] it usually pulls apart at the worst access point.
Its nicely looped to collect water. hth.
Regards Ian.
Re: Peugeot Bipper
Posted by Steve Sneap on November 20, 2013, 7:38 am, in reply to "Re: Peugeot Bipper" Stephen Sneap
Snap on software fault!!! Good job they don't make cars. Steve Sneap
on November 15, 2013, 9:47 am, in reply to "