Hi everyone.
Has anyone got a Pico capture of the crank and cam sensor signals?
The above vehicles injector drive signals disappears
in fact it has only been see a few times during testing.
The signal voltage and current under cranking doesn't all ways show enough duration though amplitude appears high enough.
I'm trying to find out what stops the injector signal initiating and was thing if the cam timing was out sync would this stop it?
I have had the car running for about 15 secs and it would seem the engine is mechanically capable of combustion and during this time i recorded a good injector signal(as per the exemplar on Pico Scope software.
Any help on this is welcome,thank you for reading
regards Nigel.