Diesel Diagnostics

Back to Forum

Post a Response

Renault Clio 1.5 2005 - Management lamp coming on, new EGR fitted - Fixed #

Posted by Mark Robins on July 19, 2010, 4:38 pm

Year of Manufacture *: 2005
Engine Size and Code *: 1.5cc (K9K 704 - Delphi dCi
( Optional ) Scanner Used: Autocom
( Optional) Fault Codes: DF028 EGR solenoid valve circuit, at minimum limit

New EGR fitted (old one not closing feedback voltage High), still got management light coming on after short drive but is no longer loosing performance.

Scoped Feedback sensor output while activating through serial socket, output looks OK and ground and feeds look OK
Searched the forum and there seems to be some disagreement over whether or not this component needs to be calibrated or not, any info greatly received.

Re: Renault Clio Management lamp coming on.

Posted by Kevin Apps <iframe src='https://members.boardhost.com/ukautotalk8/info/user=UKAT2589' width='330' height='300' border=0 style='border:none;'> on July 19, 2010, 6:14 pm, in reply to "Renault Clio Management lamp coming on."

Mark
I,m sure the autocom can 'adjust' the EGR.
Kev.

Re: Renault Clio Management lamp coming on.

Posted by Matt Booth <iframe src='https://members.boardhost.com/ukautotalk8/info/user=ukat3028' width='330' height='300' border=0 style='border:none;'> on July 19, 2010, 10:13 pm, in reply to "Renault Clio Management lamp coming on."
Matthew Booth

Had this on a Kangoo before. Replaced egr which was faulty but fault code would return after a short drive. Had to be adapted which stopped the fault code coming back.

Matt

Re: Renault Clio Management lamp coming on.

Posted by Dale Message <iframe src='https://members.boardhost.com/ukautotalk8/info/user=ukat3070' width='330' height='300' border=0 style='border:none;'> on July 19, 2010, 11:34 pm, in reply to "Renault Clio Management lamp coming on."
Dale Message

Did one of these on the same model last week, fitted it but the code came back. Re-adapted it with Autodiagnos which then solved the problem.

Re: Renault Clio Management lamp coming on.

Posted by Mark Robins <iframe src='https://members.boardhost.com/ukautotalk8/info/user=UKAT1448' width='330' height='300' border=0 style='border:none;'> on July 22, 2010, 8:33 am, in reply to "Re: Renault Clio Management lamp coming on."
Mark Robins

Re-set adaption values and then road tested vehicle for 15 miles all seemed good, customer picked up the car and after starting from cold MIL came back on within 4 miles. I'm not sure if re-setting adaption values is the correct procedure; or is there a specific adaption for the EGR? I'm starting to think maybe a wiring issue but it's so intermittent it's going to be difficult to find.

Re: Renault Clio Management lamp coming on.

Posted by Aidan Birley on July 22, 2010, 1:52 pm, in reply to "Re: Renault Clio Management lamp coming on."
Message modified by board administrator July 22, 2010, 3:02 pm

Hi Mark

If applicable to your model, it will be a separate function to adapt / calibrate EGR.

Aidan

Re: Renault Clio Management lamp coming on.

Posted by Darren Bamford <iframe src='https://members.boardhost.com/ukautotalk8/info/user=UKAT5465' width='330' height='300' border=0 style='border:none;'> on July 22, 2010, 7:44 pm, in reply to "Re: Renault Clio Management lamp coming on."
Darren Bamford

Hi Mark

If your engine code index is correct then models with K9K 700 - 702 - 704 - 706 - 710 - 712 need to be programmed when the EGR valve is replaced.

Also I would be quite confident that the engine ECU will also require Reprogramming with improved software.

If the EGR valve is replaced, it is essential to program the new valve's offset position. To do this, erase the old offset
using the EGR programming deletion procedure and run command RZ002 EGR valve adaptive.

you will need the services of a local independent specialist or the Dealers.

HTH

Darren....

Fixed #

Posted by Mark Robins on July 30, 2010, 10:00 am, in reply to "Re: Renault Clio Management lamp coming on."
Message modified by board administrator July 30, 2010, 3:20 pm

Thanks everyone, erased and reset EGR values using Renault Clip, problem fixed.

Mark Robins.

« Back to index

[ Diesel Diagnostics ]

Copyright © uk autotalk