Nissan Primestar DCi 100 2004 (54) - Will only rev to 2000 rpm, no fault codes #Archived Message
Posted by Philip Nicholls on January 19, 2009, 10:24 pm
Vehcile came in running, but will only rev to 2000 rpm, No code except usual heater plug circuit, From cold, vehcile start's but sounds like its firing on 3 cylinders, you can then rev to 2000, revs, then after couple of minuits starts to smoke. Rail prssure at tick over 354bar, seems ok, 2 earths, 5 v feeds at pedal switch, leak of check didnt fill bottles, put this down to bad running, checked air filter, change air flow sesnor, check fuel filter, for filings etc ok., remove drive from high pressure pump, ok, not broken up. removed egr,checked end piece ok. all injectors seem ok on scope, any ideas. Thanks phil