Back to Forum
Post a Response
    Hyundai H100 Y reg 2.5TD D4BF engine Archived Message

    Posted by Richard Endean on October 7, 2008, 5:57 pm

    Starts and runs ok but when you try to pull hard - usually above 2500rpm, the 'check engine' light comes on and it goes into limp home mode. If you change up a gear it seems to reset itself until you push the engine again.
    It has a 16pin socket under the fusebox with pins in 7 and 15 but I can't get any comms with KTS or Actia. Does anyone have any info like a wiring diagram - or any common faults? I need to do starter and ring gear as well as a service so things are getting a bit marginal financially!!
    TIA
    Richard

    Message Thread:


Copyright © uk autotalk