Back to Forum
Post a Response
    peugeot 406, HDI, eng code RHY Siemens, 53 plate Archived Message

    Posted by Daniel Herrera on September 15, 2008, 10:06 am

    Went to start it after parking for a while and the car wont start.

    Using pp2000:

    No codes present at engine or BSI.

    Checking live data, the rail pressure goes up to 290 bar as requested, but it does not inject. (see pics)

    On live data I noticed as well that the Crank/Cam synchronization says NO, (I thought this was because it hadn't fired?)(see pic)

    I checked reading of the cam and crank sensor both of them look OK.

    I removed the Cam sensor from its place and doing this the system recognize the problem and not pressure on rail is builds up.

    The ECU has been checked and is fine.

    So I've checked almost everything and still nothing, the couple of thing that still make me think are the immobiliser parameters on ECU and BSI,

    Under ECU conditions stands:

    "Status of the Coded engine immobiliser programming"= -----
    (see [pic)

    I checked this in another HDI and there stood "ECU MATCHED"

    As well under BSI it stands:
    BSI Unlocked= NO

    -I Virginised the ECU and reprogrammed it and rematched it but still keep saying the same, I haven't done anything to the BSI.


    Some help will be much appreciated!

    Daniel
    [img]http://Photo sharing and image hosting - EchoPic[/img][img][img]http://livedata while cranking[/img][img]http://BSI LIVE DATA[/img][img]http://NOTE THE LINE WITH THE CROSS (BSI LIVE DATA)[/img]

    Message Thread:


Copyright © uk autotalk