Back to Forum
Post a Response
    Re: Ford focus 1.8 TDCI 115 ps Archived Message

    Posted by Dave Harney on March 27, 2008, 4:36 pm, in reply to "Ford focus 1.8 TDCI 115 ps"

    Hi Nigel,
    Some Ford info....
    P2288 (Pressure higher than expected)
    Symptoms:
    * This trouble code often occurs in conjunction with other trouble codes.
    * Engine frequently undershoots to a stop.
    * Engine will not start up.
    Causes:
    * Loose contacts (corrosion) on the wiring harness connector of the fuel
    metering valve, or the connector is not pushed together properly. Check wiring
    harness connector to ensure it is connected correctly and that the pins are not
    corroded. Use IMV cycle test (located in WDS toolbox) if available on this
    vehicle.
    * Fault with IMV wiring harness. Use wiring pinpoint checks available on WDS.
    * Fuel metering valve stuck. Use IMV cycle test if available on this vehicle.
    * Loose contact on the fuel pressure sensor wiring harness connector (see
    TSB37/2003). This tends to happen more rarely.
    * If DTC P0191 is also set, check RPM signal is present during cranking. If not
    check crank sensor.
    Regards
    Dave

    Message Thread:


Copyright © uk autotalk