Ivenco 75e17 Tecter - Non running issues #Archived Message
Posted by aidan birley on March 21, 2007, 7:10 pm
Hi All
Not sure if any of you chaps do any truck work, but no harm in asking.
Got the above truck in bosch common rail set up.
No running issues, but edc lamp comes on intermittently at idle speed. fault code 320 RPM sensor in plausible signal. memory code, will clear but comes back after just a few miles drive.
Vehicle new to our customer, just purchased. look like the Crank & cam sensor have been changed in the not to distant past. changed crank sensor (only £20) but just the same as I expected. Phonic wheel looks fine. gear drive to cam so unlikely I thing to be a timing issue I feel.