on January 22, 2015, 9:56 am, in reply to "Re: ford transit 2.4 tdci non start flags crank sensor fault"
this did work but at only 1.7 volts.
found very poor connection at ecm.
the anvil lever and plastic cover is missing on the smallest block and the jelly/sealant has all gone sticky and runny and plastic bits falling apart.shuffling connector on ecm shows bad connection as vehicle starts now intermittently.
loom at other end at crank sensor is also poor. needs new loom.it is as if some nasty stuff has contaminated the top connecter. thanks for your help
best regards john
Message Thread 
Ford Transit 2.4 TDCi 2007 - Non start, code for crank sensor # - John Sartain January 20, 2015, 11:30 am
« Back to index | View thread »