Mercedes Benz C270 CDi 2000 - Will not rev over 3000 rpm, P0100, P2201 and P0105 #
Posted by Les Smith on December 11, 2009, 10:26 pm
Message modified by board administrator December 14, 2009, 12:15 pm
Year of Manufacture *: 2000 Engine Code or CC *: 2.7 AUTOMATIC ( Optional ) Scanner Used: SOLUS
Looked at this for another garage. codes p0100 and p2201.P0105 pressure sensor cleared. On start up revs OK but a couple of WOT then will not rev above 3000. Stop and restart and same again. Check Maf(which had been changed with merc part).When revs are ok I have expected readings but flat lines to zero when fault there. I have 12v an earth and 5volts on wires. No volts on the forth wire. ran out of time but will have a look next week. Any thoughts will be very welcome Fuel pressure 258 and rising to 685 regards Les
|