Stoneridge Engineering Home |
new bathroom wiring
Posted by Patti on 10/6/2003, 3:40 pm I have the black wire & the white wire from the power wire coming from the panel connected to the line side of the GFI. now how do I go about connecting the black from the load side of GFI to the other two switches. Do I pigtail and if so could you send me a little schematic? PLEASE HELP
|
Re: new bathroom wiring
Posted by Bert Hickman on 10/7/2003, 7:14 am, in reply to "new bathroom wiring" Hi Patti, This is a Tesla Coil and High Voltage message board, so your question is a bit off topic. However, you do sound a bit desperate, so we'll give it a shot. Connect the hot LOAD terminal of the GFI to one side of each switch (pigtailing them). Connect the other terminal of each switch to the hot side of the light and fan respectively. Connect the other (neutral) side of the fan and light to the neutral LOAD terminal of the GFI. This permits both the fan and vanity light to be protected by the single GFI. Good luck and be very careful! -- Bert --
|
Re: new bathroom wiring
Posted by Patti on 10/7/2003, 6:01 pm, in reply to "Re: new bathroom wiring"
|