--- Message Board --
[ Post your Response | --- Message Board -- ]
Posted by N Revelis on 7/28/2011, 4:52 pm
hunting for an enclosed neon spark discharge to use on a Don Smith device . With a varister plan to keep voltage at 2000 . looking at waveform of nt tran. the voltage fluxs about 200 v. My thinking is that setting this up would have a considerable impact of the final output frequency by shorting the signal and recovering before one cycle is completed. Is it correct to have the nominal voltage on discharge tube at the average and the spike voltage at 200 v or should it be smething else.Can not find gas discharge tubes at the 2000 v nominal. if someone can point me to a source i would be very grateful. thank you very much Nick
This web site is maintained
by Bert Hickman.
� 1999-2012, All rights reserved. No portion of this web site may
be reproduced without written consent.