That's a nice offer - but I am already adapting "tuck-fold" joints molded from my own Revell Avenger, as
I posted recently (though I didn't go into detail). I'm very busy lately, so haven't been putting a lot of explanation into my updates (but if you look closely at the pics and think a little, you should be able to read a lot "between the lines"). There was once a thread showing the start of my Grumman-type wingfold jig project - long since dropped off the board - but it will reappear as part of this thread.
Meantime, congrats on finishing your Boston - where was the Region 12 show held?
Be advised: another thing which lately I don't have time to mess with is fuzzy (or otherwise lousy) pictures - so, whatever you may send in, first make sure the pics are (at least) in focus, and at least decent, OK Mikey? Thanks again, buddy.
Cheers,
-Matty