The L.C. Smith Collectors Association

The L.C. Smith Collectors Association
[ The L.C. Smith Collectors Association ]

Interesting video of working on a LC Smith

Posted by Gary Rennles on August 25, 2023, 3:15 pm
Edited by board administrator August 25, 2023, 3:27 pm

I thought there might be some interest in this video

https://www.youtube.com/watch?v=M4nWRagYsKI&t=104s

Re: Interesting video of working on a LC Smith

Posted by Drew Hause on August 25, 2023, 3:48 pm, in reply to "Interesting video of working on a LC Smith"

Thanks Gary. I added a link to the video in the "Disassembly and Reassembly" FAQs

Re: Interesting video of working on a LC Smith

Posted by Gary Rennles on October 13, 2023, 11:08 pm, in reply to "Interesting video of working on a LC Smith"

This is a follow up video from the previous one.

LC Smith bottom metal addendum for installing of bottom plate.

This video titled :
Master Gun Maker Disassembles an L.C Smith Shotgun
is one of the best videos I have seen so far.

Tool to correctly compress the LCS top lever spring

Posted by Jent P Mitchell III on October 14, 2023, 8:49 am, in reply to "Re: Interesting video of working on a LC Smith"
Edited by board administrator October 14, 2023, 12:24 pm

Re: Interesting video of working on a LC Smith

Posted by Drew Hause on October 14, 2023, 12:26 pm, in reply to "Re: Interesting video of working on a LC Smith"

Thanks again Gary. I added the additional Youtube to the FAQ "Disassembly and Reassembly (abandon all hope

)" section

Tool to easily compress the LCS top lever spring

Posted by Jent P Mitchell III on March 13, 2024, 8:40 am, in reply to "Tool to correctly compress the LCS top lever spring"

Here are some pictures of the LCS top lever tool ..... Jent.

Re: Interesting video of working on a LC Smith

Posted by Jerry Andrews on March 17, 2024, 4:39 pm, in reply to "Interesting video of working on a LC Smith"

And I’m sorry but this is another bad example of how NOT to install your main spring. Geez!!!!

Aligning top lever shaft to trigger plate

Posted by David Williamson on March 20, 2024, 1:14 pm, in reply to "Re: Interesting video of working on a LC Smith"

The way he shows this process using a 3/32" drift punch and a flat head screwdriver with a "V" notch is the way Hunter Arms did it and you can see this in Brophy's Book "L.C. Smith Shoguns".

« Back to index

999

[ The L.C. Smith Collectors Association ]