Re: Early Smith Barrel Stop Disassembly Archived Message Posted by Drew Hause on March 20, 2018, 8:30 am, in reply to "Early Smith Barrel Stop Disassembly " To remove, drive retainer pin out, rotate joint check until activator pin pops out into ejector (extractor) hole. Remove activator and slide joint check out. Courtesy of David Williamson To reinstall, the activator can only go in one way. Take a dowel and push the activator to compress the spring in the joint check and then rotate joint check to hold in place. Message Thread: Early Smith Barrel Stop Disassembly - Bill Murphy March 19, 2018, 7:30 pm Re: Early Smith Barrel Stop Disassembly - Drew Hause March 20, 2018, 8:30 am Re: Early Smith Barrel Stop Disassembly - David Williamson March 20, 2018, 10:28 am Re: Early Smith Barrel Stop Disassembly - Bill Murphy March 20, 2018, 4:32 pm Re: Early Smith Barrel Stop Disassembly - Bill Murphy March 20, 2018, 4:35 pm Re: Early Smith Barrel Stop Disassembly - David Williamson March 20, 2018, 6:39 pm Re: Early Smith Barrel Stop Disassembly - Bill Murphy March 21, 2018, 2:54 pm Re: Early Smith Barrel Stop Disassembly - Bill Murphy March 22, 2018, 5:20 pm Re: Early Smith Barrel Stop Disassembly - Bill Murphy March 24, 2018, 5:11 pm Re: Early Smith Barrel Stop Disassembly - David Williamson March 25, 2018, 6:48 am Re: Early Smith Barrel Stop Disassembly - Bill Murphy March 25, 2018, 7:00 pm   Searching