Re: Forcing cone question Archived Message Posted by William on October 12, 2017, 5:12 pm, in reply to "Re: Forcing cone question" So the 1 7/8" in 12 1/2" is just the ratio at which it tapers? I think I get it. So working backwards if the taper is .069, the length of the cone is right at 1/2"? I think I'm over thinking it! Message Thread: Forcing cone question - William Norton October 12, 2017, 1:39 pm Re: Forcing cone question - David Williamson October 12, 2017, 3:39 pm Re: Forcing cone question - William October 12, 2017, 5:12 pm Re: Forcing cone question - Gary Rennles October 12, 2017, 6:59 pm Re: Forcing cone question - David Williamson October 12, 2017, 7:51 pm Re: Forcing cone question - Marcus Merritt October 15, 2017, 4:29 pm   Searching