shotgun barrel dent raising gage pins Archived Message
Posted by Jent P Mitchell III on April 27, 2015, 4:07 pm, in reply to "Re: shotgun barrel dent removal gage pins"
Yes, you need to put a 45/45/90 degree or a 30/60/90 degree slope on the edge of the gage pin to keep the sharp edge of the pin from cutting metal off of the dent. The gage pins are made from a very hard metal. The metal shop that helped me modify these pins used a grinding stone set up on a large lathe to cut the angle on the pins. They cut both ends of the pins....Good Shooting To You, Jent
|
|