Re: What method were the original LC Smith screws finished Archived Message Posted by Ron on October 16, 2009, 3:49 pm, in reply to "Re: What method were the original LC Smith screws finished" David, Thanks for your help. Yes, I am planning to replace a couple of screws. In the past I have used Oxpho blue with good results but was wondering if niter bluing or some other method was more correct. And was just curious as to how the original screws were finished. Thanks, Ron Message Thread: What method were the original LC Smith screws finished - Ron Fankhauser October 15, 2009, 4:58 pm Re: What method were the original LC Smith screws finished - David W October 16, 2009, 2:01 pm Re: What method were the original LC Smith screws finished - Ron October 16, 2009, 3:49 pm Re: What method were the original LC Smith screws finished - Dewey Vicknair October 20, 2009, 7:15 am Re: What method were the original LC Smith screws finished - Ron Fankhauser October 20, 2009, 9:59 am Re: What method were the original LC Smith screws finished - David W October 21, 2009, 3:35 pm Re: What method were the original LC Smith screws finished - Ron October 21, 2009, 11:12 pm Re: What method were the original LC Smith screws finished - Randall October 22, 2009, 2:03 am Re: What method were the original LC Smith screws finished - dan October 22, 2009, 2:36 am Re: What method were the original LC Smith screws finished - Tom Salzer October 24, 2009, 9:55 am   Searching