2013 Fall Harvest Fest Truck and Tractor Pull Rules
General Rules:
 Driver must have valid license
 Helmets and seatbelt must be worn by driver.
 Driver must be fully clothed and while not required, it is recommended driver wear helmet. Fire
extinguisher recommended
 Absolutely NO Alcoholic Beverages are allowed!
 The promoter and officials reserve the right to reject a puller if there is suspicion of alcohol
consumption or if the vehicle does not meet the above requirements.

RWB Street Gas Rules
1. Must be street legal with valid inspection and tags
2. 3" clevis or loop hitch required
3. 24" hitch height maximum

6200 Gas Shoot Out Rules
1. 505 Cubic inch engine limit
2. NO dominator carbs
3. 35" DOT approved tires
4. 23" hitch height maximum
5. Driveline must be 1 ton or UNDER

8050 RWB Diesel Rules
1. Weight bars on front are permitted, weights must be fastened securely to truck.
2. No nitrous, propane, or any type of fuel enhancement – water injection is permitted.
3. Tires must be street-legal (no cutting of tires).
4. 8,050 lb. weight limit (driver and truck) – NO EXCEPTIONS.
5. All trucks will pull in the same class (duelly’s, 4WD). Hood stacks are permitted.
6. Chips are allowed.
7. NO RIDERS.
8. Hitch height cannot exceed 24”.
9. No bumper hitches allowed, must be Reese-style hitch or trick hitch.
10. Must be at least a 3” loop/clevis type hitch.
11. The promoter and officials reserve the right to reject a puller if there is suspicion of alcohol
consumption or if the vehicle does not meet the above requirements.
12. Track officials, promoters and fair officials must be obeyed at all times at risk of disqualification.
13. The Tech Officials for this class have final ruling on all class rules.
14. The Tech Officials reserve the right to inspect all vehicles at registration and weigh-in.
15. ONE DRIVER AND ONE HELPER ONLY, ADMITTED FREE AFTER INSPECTION.
16. Seat belts and Helmets MUST be worn.
17. Fire Extinguishers are highly recommended. 2013 FallHarvest Fest Truck and Tractor Pull Rules

15000 Farm Stock Rules
1. Torque Converters and automatic shifts are permitted. No slipper clutches.
2. Contests open to two (2) wheel drive, rubber tired tractors. No 4-wheel drives, dual tires,
chains or studded tires. All power must be transmitted through the rear wheels.
The width is limited to a maximum of 24.5”.
3. No external engine modifications. Factory pump for make and model of tractor. If
turbocharger has been added, must be OEM stock turbo and manifold for make and model of tractor.
No performance enhanced updated turbos allowed in stock class. No open turbo intakes. All intake
hoses must be stock from factory.
4. No mixing of fuels allowed. Tractor must use the fuel the factory engine was designed for. No fuel
additives or water injection.
5. A no-stripping regulation will be enforced only if parts removed render the tractor unsafe to drive.
Specific items illegal to remove are either front wheels, hood, grill assembly, rear fender. All sheet
metal, hoods, fender, dash, grills and fuel tanks have to be in original location as from factory.
6. Any supplement to the drawbar such as hitching rings or plow couplers must conform to the 20”
maximum height to the top of the device, parallel to the ground and a minimum of 18” from the
center of the rear axle. Supplement drawbars must be a minimum of 1” thick and with at least a 3”
hole. No weights or brackets may be within 8” side to side or 12” above center of hook.
7. Maximum RPM - 2800 RPM. No building of extreme RPM’s or turbo boost allowed on take off.
8. Straight pipes will be allowed in place of vertical muffler if they extend 18” above the hood.
Underneath exhaust systems must be a factory system in original condition. NO RAIN CAPS ALLOWED.
9. Custom built weight frames are allowed behind front wheels. No weights shall exceed more than 24”
in front of the foremost portion of the tractor. No weights may extend past the rear tires and all
weights must be secured. Any weight lost during pull is automatic disqualification.
10. Skid bars and side shields are recommended for insurance regulations. Skid bars must be a minimum
of 32” behind center of rear axle. Bars must be no more than 10” off ground. Contact patch must be 5
sq. in. (5” X 5”). Bars must be able to support weight of tractor in heaviest class. If tractor is not
equipped with skid bars, forward progress will be stopped when front wheels are an unsafe distance
from ground.
11. No alteration to wheel base or frame. Front end must be as available from the manufacturer for make
and model of tractor.
12. Tractor shall be subject to official Tech Inspection to pull.
13. Driver must be fully clothed and while not required, it is recommended driver wear helmet. No shorts.
14. Any equipment lost while hooked to sled is an automatic disqualification.
15. Tractor can only hook in two (2) classes.
16. No excessive wheelies on take off. Front wheels are limited to 6” off ground.
17. All PTO’s, hydraulics must be operational like on the farm.
18. All engines have to be original size for tractor. No factory updated engine.
19. All injection pumps must be OEM for make and model of tractor. No inline pumps for
rotary.
20. Stock Farm cannot pull in Tweaked Farm Classes.
21. No cut tires.
22. If tractor is equipped with rollover equipment (rollover cage, etc.), driver must wear
seatbelt. 2013 FallHarvest Fest Truck and Tractor Pull Rules

12000 Hot Farm Rules
1. 466 Cubic inch, limited with a 2 percent allowance (which means a max of 475 cu in) ** Unless it
comes from a factory with more cubic inches, then must run factory pump and charger and factory
RPM.
2. One (1) turbo that has a 3LM center section with a 2.4 intake with cast # 693613 and a 241 exhaust
housing.
3. No slots, plugs or reducers allowed on or in turbo charger.
4. Intake hose must be easily removable so that charger can be checked.
5. Exhaust must be at least 18" above the hood and have two 3/8 bolts in the pipe forming a cross. This
is to prevent parts from exiting the pipe.
6. Injection fuel pump no larger than an "A" pump. Diesel fuel only. No accelerants such as propane or
alcohol mixtures.
7. No water injection or water injection parts allowed on tractor.
8. Tractor must have a steel flywheel or have a safety blanket or 3/8 inch x 6inch 360 degrees around
the flywheel area of tractor
9. Intercoolers allowed Electric fans only. No belt driven fans allow.
10. Max Tire size will be 20.8 X 38 or metric equivalent
Tires can have a top cut only on cleat. No alterations to the front edge of cleat
11. Aluminum rims are allowed.
12. 20" Hitch height
13. 20" minimum front center of axle to hook point
14. Side shields allowed only if factory equipped
15. Roll over protection is strongly recommended but not mandatory. If you have it you need to wear a
seat belt.
16. Wheelie bars must have 5 X 5" pad, no more than 10 inches from the ground. Must be 3 inches back
from farthest point of rear tire to front of the pad.
17. A working air shut off cable with a 2 inch ring mounted at the rear of the tractor for easy hookup to
the sled.
18. All tractors must be equipped with a working fire extinguisher
19. All tractors will be safety teched.
20. 17 mph speed limit with NO GRACE ( which means that at 17.1 you will be disqualified)
21. Any tractor may not participate more than once in any class (excluding test puller unless it is run at
the end of the class as an exhibition run and the promoter permits it
22. Anyone refusing to be teched will be disqualified.