[ Post a Response | The SteelNavy.Com Message Board ]
Posted by Jon Ryckert on February 13, 2025, 11:58:51, in reply to "👍. NT"
nm 
Previous Message
nm Previous Message
You are welcome, Jon, after tried other tools and considering the price of those 3D printed kits, the price I paid for the ultrasonic cutter worth it. Previous Message
nm Previous Message
I only use it for 3D printed parts, but the introduction clip shows it can cut plastic. Previous Message
Don't know anything about those cutters, so just wondering if would burn the plastic. Previous Message
The WonderCutter S Ultrasonic Cutter. Ordered from MicroMark. Previous Message
Nt Previous Message
I use Ultrasonic Cutter. It is expensive but gives good results. I have tried all kind of tools, and this is the best one. Previous Message
So I have a fair number of 3D printed 1/350 aircraft from several companies - Orange Hobby, 3D Wild and L'Arsenal. I'm having a devil of a time getting them off their print matrices intact. The H-53 blades are particularly bad - one clip and the blade shatters instantly. F/A-18 landing gear too. Is there a good video out there for despruing these things? Thanks all in advance.
[/q
Responses