[ Post a Response | The SteelNavy.Com Message Board ]
Posted by Ron Smith on February 9, 2025, 11:48:15, in reply to "Re: Super glue and 3D printed parts."
Bunker Studio is SLA and does not use waxy supports. 
Previous Message
Maybe the 3D parts were not sufficiently cured, or still had a waxy support. Place in bright sunlight a few hours (or UV light), or wash in alcohol (to remove wax). Previous Message
I purchased some Bunker Studio parts for my 1/200 Bismarck. When attaching the 3D printed chocks to the deck, for some reason, the super glue had a hard time getting to stick the parts together. After the third or so attempt, the parts were glued together. Now, I didn't wash the parts as I am led to believe that is not required. Will wash the next time and see what happens. Has anybody else ran into this issue? Any replies welcomed, Jon
Responses