[ Post a Response | The SteelNavy.Com Message Board ]
Posted by Larry TM2(SS) on July 15, 2023, 7:15:11, in reply to "Advice on wooden kits"
I've seen where they use steam to bend wood for furniture. 
Previous Message
I'm going to try my hand on my first wooden kit, the Dumas 1935 cabin cruiser. The problem is, the thin wooden sheets comprising the laser-cut parts have warped.
I'm thinking of soaking them in very hot, possible boiling water and pressing them between two flat surfaces under pressure.
Anybody have comments on thhis, or a better idea?
Responses